Page 95
VIS CAM 300/400 Installation Manual
Appendix E: Moxa N-Port 5232 Configuration
Serial port 1 settings:
Port alias:
D1 – enter desired name of this specific serial port.
Baud rate:
9600
– specify the desired baud rate of the serial port – the TLS200 light
sensor requires 9600 as standard.
Data bits:
8
– specify the desired size of the data bits used - the TLS200 light sensor
requires 8 as standard.
Stop bits:
2
– Specify the desired size of the stop bits used - the TLS200 light sensor
requires 2 as standard.
Parity:
None – feature not used in communication with the light sensor.
Flow control:
None - feature not used in communication with the light sensor.
Fifo:
Enable
- the TLS200 light sensor requires FIFO as standard.
Interface:
RS-485 2wire
– the communication with the TLS-300 light sensor is standard
2-wire RS-485.
Enable – apply the above settings to all serial ports –
rename port 2 port alias to D0.
FIGURE 89.
Standard configuration of Serial settings for port 1:
Summary of Contents for Vehicle Imaging Subsystem 300
Page 2: ...Page ii Vehicle Imaging Subsystem 300 400 ...
Page 12: ...Page xii List of Tables ...
Page 114: ...Page 102 VIS CAM 300 400 Installation Manual ...
Page 115: ......
