Page 36
VIS CAM 300/400 Installation Manual
System Set-Up
FIGURE 31.
Initial Camera Alignment Display example.
8.
Turn on the “Roll Bar” display on the Setup computer and then roll the camera mount until the hor-
izontal bumper and trunk seams on the vehicle appear perfectly level with the horizontal line of the
display. Use one 7/16" closed-end wrench on the roll gear to fine-tune the roll angle. Hold the roll
position with the wrench while you use a second wrench to gently tighten the other roll bolts. Then
apply both wrenches to corresponding bolts on opposite sides of the mount. Twisting in opposite
directions to fully secure all of the roll bolts. This approach prevents the roll adjustment from
changing while you tighten the bolts. See Figure 32.
Summary of Contents for Vehicle Imaging Subsystem 300
Page 2: ...Page ii Vehicle Imaging Subsystem 300 400 ...
Page 12: ...Page xii List of Tables ...
Page 114: ...Page 102 VIS CAM 300 400 Installation Manual ...
Page 115: ......
