![background image](http://html.mh-extra.com/html/jai/vehicle-imaging-subsystem-300/vehicle-imaging-subsystem-300_installation-manual_631589029.webp)
Page 17
VIS CAM 300/400 Installation Manual
Installing the Vehicle Imaging System
3.1.2 Optional Side Mount
1.
Attach the pipe clamps approximately 6-inches apart on a vertical
mounting surface as shown in Figure 13.
2.
Loosen the four Allen screws and remove the flange from the
mounting base. Figure 10, “Install the traffic light sensor.,” on
page 15.
3.
Route the Traffic Light Sensor end of the TLS-300 signal and the
power cable through the pipe and flange.
4.
Screw the flange onto the pipe somewhat tightly to allow subse-
quent minor adjustment
5.
Place the pipe in the pipe clamps and tighten them to secure the
pipe to the vertical mounting surface.
6.
Attach the Traffic Light Sensor body to the flange and secure it
with the four Allen screws.
7.
Orient the Traffic Light Sensor such that the white reflectors are
parallel to the trigger plane with side B facing (visible from) the
trigger plane
8.
Route the free end of the cable to the VIS J-Panel in accordance
with local code requirements
9.
Connect the color-coded wires to the J-Panel connector X3 as
described in Section 3.3 on page 21. Make sure that no power is
applied when performing any wiring operation.
FIGURE 13.
Pipe clamps should be about
6-inches apart on a vertical surface.
3.2 Installing the Camera(s)
In general, the camera(s) should be aimed at the most likely cross-lane position of the vehicle license
plates. See “Installation Preparation” on page 6 for general site layout guidelines. To install the
camera(s):
1.
Attach the camera mount to the camera enclosure using the included mounting bolts and washers.
Refer to
Figure 14.
FIGURE 14.
Camera Installation
Approximate weight 6.6 kg
Measurements include the extended sun shield
Summary of Contents for Vehicle Imaging Subsystem 300
Page 2: ...Page ii Vehicle Imaging Subsystem 300 400 ...
Page 12: ...Page xii List of Tables ...
Page 114: ...Page 102 VIS CAM 300 400 Installation Manual ...
Page 115: ......