JAI Vehicle Imaging Subsystem 300, Installation Manual

Page: 42 / 116

Page 30
VIS CAM 300/400 Installation Manual
Installing the Vehicle Imaging System
3.5 Trigger Options
3.5.1 Installing The Laser Vehicle Detector
The connection from the Laser Vehicle Detector to the VIS CAM 300 is shown in Figure 29 and
Table 10
FIGURE 29.
Connection for LVD to VIS CAM 400.
TABLE 10.
Wiring for LVD to VIS CAM 400.
The cable must be shielded and the shield connected to the metal at the cable entry in the camera house.
The switch S3 and/or S5 on the J-panel must be in position “positive going” (pushed towards X1/X2) to
enable the laser trigger input on the IO Board.
X7 Pin # Signal Description Connection to
1 24V (Fused 0.5A) Power to laser Laser power input
2 Gnd Power gnd Laser ground
3 Trigger Trigger from laser Trigger out on laser
4 RS485- Transmit to laser Receive input on laser
5 RS485+ Receive from laser Transmit output on laser
6 Gnd Communication gnd Communication gnd on laser
7 nc No connection -
8 nc No connection -
1 2 3 4 5 6 7 8