Iveco EUROCARGO, Instructions Manual

Page: 111 / 226

EUROCARGO Euro 6
–
APPLICATIONS OF SUPERSTRUCTURES
APPLICATIONS OF SUPERSTRUCTURES
3.4 CONTAINER APPLICATION
21
–
Printed 603.95.747
–
1st Ed. - Base 12/2013
200446
Figure 16
1. Counter chassis
2. Brackets
3. Plates
4. Joint cover
A. Mechanical suspensions
B. Air suspensions
Heavy-duty services
Table 3.5 shows which vehicles may be ordered for heavy-duty services and the indications for the main sections of the counter
chassis.
For its dimensions, depending on the section modulus W
x
, see table 3.2.
In the event of tippable superstructure assembly on vehicle chassis already equipped with brackets, replace them with longitudinal
and transverse seal plates, in the segment between the front engine axle suspension support and the rear chassis end or apply addi-
tional plates
Special attention must be paid to ensure adequate stability to the vehicle during the rear tipping of the body.
For vehicles that are transformed even through two rear axes, is prescribed that:
●
the box section for the longitudinal reinforcement section (see Figure 3.3) involves the segment between the rear wire and
approx. 1300 mm in front of the centre line of the two axles;
●
the diagonal cross bracings involve the area between the centre line of the double axle and the rear end of the chassis;
●
the tipping support is to be positioned no more than 1400 mm from the centre line of the double axle.
Table 3.5
Model Wheel base (mm)
Section modulus W
x
[cm
3
] of the minimum section bar of the counter chassis
(Yield point of the material used = 360 N/mm 2 )
60K, 65K, 75K T T 39