Iveco EUROCARGO, Instructions Manual

Page: 148 / 226

14
EUROCARGO Euro 6
–
POWER TAKE-OFFS
POWER TAKE-OFFS
4.6
PTO MANAGEMENT
–
Printed 603.95.747
–
1st Ed. - Base 12/2013
Table 4.5
Button Function
RES / OFF
Activate/deactivate intermediate engine speed. The factory intermediate engine speed
setting is 900 rpm, which may be altered by the driver.
SET+ / SET- Increase/reduce active intermediate engine speed setting
Accelerator pedal Active
Max. rpm possible with SET+ button or accelerator pedal
N
LL
(1)
÷ maximum rpm permitted by engine
Torque delivered Maximum specific engine torque
Conditions for deactivating intermediate engine speed function
●
Operation of the brake or clutch pedal
●
CC Off activated
●
engine brake operated
●
lntarder operated
●
PTO mode 0 deactivation speed
●
'NEUTRAL' not selected (automatic transmissions)
(1)
N
LL
= rpm at idle speed.
PTO modes 1, 2, 3 (configurable)
Three different and independent PTO maps may be programmed on the electronic control units by IVECO Service. The engine
can, of course, only operate with one PTO mode at a time. The following priorities are assigned to the modes:
●
PTO mode 3: high priority;
●
PTO mode 2: medium priority;
●
PTO mode 1: low priority;
●
PTO mode 0: driving mode.
Note The Bodybuilder must observe this order of priority when managing the outfitting and interface outfitting. This is so as to avoid
additional costs for subsequent modifications to the wiring or reprogramming.
The following table shows the parameters making up a PTO mode. These parameters may only be programmed by IVECO Service
using an EASY diagnostic station.
Table 4.6
Parameter Possible values
Max. rpm possible with SET + button N
SET_max
(9) N
LL
÷ N
max
(2)
Maximum rpm possible with accelerator pedal N
max_acc
Engine rpm increment with SET + button 250 rpm for each second button is pressed
Engine rpm decrement with SET - button As above
Torque limiting (3) See table
Overspeed regulator curve gradient "High Idle" curve: vertical by default
Usage of CC buttons (RES / OFF / SET + / SET-) Active / inactive
Storing intermediate engine speed setting Fixed (EASY)/free (driver) (8)
'TIP' function for SET + / SET- buttons (4) Active / inactive
PTO mode deactivated with brake or clutch (independently for each mode) (5) Active / inactive
Accelerator pedal Active / inactive
Recalling stored intermediate engine speed setting with RES after activation of PTO
mode
(7)
Active / inactive
Minimum rpm value settable with SET - button. N
SET _min
(9) > 500 rpm