Isotech TTI-7-R, Operator'S Handbook Manual

Page: 91 / 120

Communications Interface
7.9 Route Command Group
The ROUTe:SCAN commands are used to control the instruments
scanner operation and configure the scanning lists.
The instrument can save up to four independent scanning lists in
none-volatile memory, each scanning list also retains its individually
programmed cycle count, trigger delay time and sample rate.
7.9.1 Route command summary
Command Description
ROUTe:SCAN:LSELect Sets the scanner mode and selects a scan list.
ROUTe:SCAN:LSELect? Queries the scanner mode and scan list.
ROUTe:SCAN:INTernal Configure the specified internal scan list.
ROUTe:SCAN:INTernal? Queries the specified internal scan list.
7.9.2 Route commands
ROUTe:SCAN:LSELect <slx>
This command is used to set the scanner mode and select the scan
list, the scanner is enabled by selecting a scanning list.
An empty scanning list can not be selected, the
ROUTe:SCAN:INTernal command should be used to configure the
scanning list.
<slx> SL1, SL2, SL3, SL4 Enable scanner
Select slx scanning list
OFF Disable scanner
Terminates the current measurement cycle and scanning routine.
Sets the Run/Hold trigger mode to Hold when enabling the scanner.
Sets the scanner operation and selects the scanning list as specified
by the command.
ROUTe:SCAN:LSELect?
Queries the state of the scanner and returns the selected scanning
list if enabled.
Returns "SL1", "SL2", "SL3", "SL4" Selected scanning list
"OFF" Scanner disabled
Page 7-23