Isotech TTI-7-R, Operator'S Handbook Manual

Page: 23 / 120

About the TTI-7-R
Table 3.2 - Measurement mode display features
PRT measurement Thermocouple Relative Ch1 - Ch2
1
Selected channel
temperature Selected channel
temperature Temperature
difference between
CM and Ch2
2
Input channel
selected
Input channel selected C M - C h 2
3 Pt100 TC Not used
4
PRT linearization
standard Thermocouple type
selected, letter
designation
Not used
5 PRT alpha value
Reference junction
mode
Not used
6
3, 4 wire
measurement
configuration
Not used Not used
7
Temperature display
units Temperature display
units Temperature display
units
8
Measured input value
in Ohms
Measured input value
in mV
Not used
9
Measurement current
polarity
Reference Junction
temperature if selected
Not used
10 Measurement status Measurement status Measurement status
11
Trigger run/ hold,
single condition Trigger run/ hold,
single condition Trigger run/ hold,
single condition
12 Measurement zeroed
indication
Measurement zeroed
indication Measurement zeroed
indication
13 Low Battery indication Low Battery indication Low Battery indication
14
Re mote/Addressed
remote operation Remote/Addressed
remote operation Re mote/Addressed
remote operation
15 R0 value in ohms Not used Not used
16
X samples taken of Y
number of samples X samples taken of Y
number of samples X samples taken of Y
number of samples
17
Logging data to none
volatile memory Logging data to none
volatile memory Logging data to none
volatile memory
18
Scanning mode ON
SLx scan list Scanning mode ON
SLx scan list Scanning mode ON
SLx scan list
Page 3-7