Isotech TTI-7-R, Operator'S Handbook Manual

Page: 59 / 120

5.7 Setting up the basic controls
You can configure certain settings on the TTI-7-R by
pressing This takes you to the options menu. The screen
displays:
Options?
Sys Set Rem
Conf Up I/F Trg Ver Quit
The table below gives a summary of all the available options.
Sys Conf Review system configuration
Set Up
Display backlight on/off Keyboard beeper on/off
Set TTI-7-R clock time Set TTI-7-R clock date
format dd/mm/yy, mm/dd/yy Set TTI-7-R clock date
Rem I/F
(lf RS232 remote interface card fitted)
Set remote interface Baud rate Set remote
interface to Talk only mode
(lf lEEE488.2
remote interface card fitted) Set IEEE
address
Trg Select Trigger mode to Run/Hold or single shot
Ver Review Model number, Firmware version number
5.7.1 Review system configuration
On power-up the TTI-7-R performs a system configuration
check searching for input channel expansion cards or
communication card.
The following information is read from each card on detection and
displayed by the system configuration display.
Communication card
RS-232, Baud rate, Character bits, Parity, Start bit, Stop bit.
IEEE488.2, Address.
Input channel expansion card
Card ID, Serial Number, Card type, Channel numbers.
To review the system configuration select Sys Conf from the
options? menu. The screen displays the system configuration.
Operating the TTI-7-R
Page 5-25