Isotech TTI-7-R, Operator'S Handbook Manual

Page: 82 / 120

Options and accessories
7.6 Measurement Command Group
The measurement command group is used to select channels,
configure channel parameters and acquire readings.
7.6.1 Measurement command summary
Command Description
CONFigure:CHANnel: Select the specified channel.
CONFigure? Query the channel configuration.
CONFigure:TEMPerature:TC Configure a channel for TC measurement.
CONFigure:TEMPerature:RTD Configure a channel for RTD measurement.
FETCh? Fetch a single reading.
READ? Initiate a measurement and fetch a reading.
MEASure:CHANnel?
Select the specified channel. Initiate a
measurement and fetch a reading.
MEASure:TEMPerature:TC?
Configure a channel for TC measurement.
Initiate a measurement and fetch a reading.
MEASure:TEMPerature:RTD?
Configure a channel for RTD measurement.
Initiate a measurement and fetch a reading.
7.6.2 CONFigure Commands
Configure commands are used to select and configure channel
parameters without triggering a measurement.
CONFigure:CHANnel {channel}
Selects the specified channel to be measured (use CONF :TEMP to
configure the measurement parameters).
Only channels that are available can be selected or the command will be
ignored.
{channel} A0, A1, A2, A3, A4
B0, B1, B2, B3, B4
Ch1 - Ch2
Terminates the current measurement cycle and scanning routine. Sets
the trigger mode to single shot. Selects the channel as specified by
the command. Sets the scanner mode to Off. Sets the logging to
memory mode to Off.
Page 7-14