Iseki TG5330, Operation Manual

Page: 72 / 176

OPERATION
71
Using Position Control
FIG. 5-30: Type of Work - Attaching/detaching imple-
ments and other operations requiring implement to be
kept at constant height above ground. Also used with tool
bars having flexible row units and implements equipped
with gauge (support) wheels.
FIG. 5-31: Lever Positions - Use position control lever, 1,
to adjust hitch and implement position.
NOTE: Front lever stop, 2, can be set to contact position
control lever in implement work position. This
enables implement to be returned to identical
position after hitch has been raised for turning,
transporting, etc. Rear lever stop, 3, can be set to
limit raising height, if required.
To Begin Work - Align Tractor and implement in field and
move position control lever, 1, forward (toward DOWN).
Adjust implement height using position control lever and
set adjustable stops, 2 and 3, as desired.
When Turning - Move position lever, 1, rearward (toward
UP) to raise implement. Finish turning and return lever
against stop to resume operation.
To Finish Work and Transport - Move position control
lever, 1, fully rearward in quadrant.
FIG. 5-32: Lowering speed can be readjusted as neces-
sary using lowering rate control knob, 4.
CAUTION: When using mounted implements
with PTO driveline, make sure:
PTO drive shaft has minimum 51 mm (2
engagement of telescoping sections, at all
hitch/implement positions.
Hitch height during raising does not bind
drive shaft universal joints due to extreme
drive shaft angles. Limiting raising height
may be required.
PTO drive is disengaged during transport.
FIG. 5-30
1
2
3
FIG. 5-31
4
FIG. 5-32