Iseki TG5330, Operation Manual

Page: 133 / 176

132
TG5330,5390,5470
FIG. 6-21: Outer element, 4, may be cleaned (if in serv-
iceable condition) using following procedures:
・ Using compressed air not to exceed 30 psi (200 kPa)
from inside element, remove loose dirt, grass, chaff,
etc. Be careful not to damage element pleats with air
flow.
・
If outer element is coated with oil or soot:
1. Prepare solution of warm water and non-foaming
detergent.
2. Soak element for thirty minutes.
3. Agitate element in solution until oil and soot are loos-
ened.
4. Rinse element until rinse water is clear.
5. Allow element to completely dry. Do not dry by using
compressed air or heat.
・ After cleaning (or washing) element examine for pin
holes, punctures, or tears. If element paper, canister
or seal show any signs of physical damage, element
must be replaced.
NOTE: Replace outer element which has already been
washed five times.
FIG. 6-21