Iseki TG5330, Operation Manual

Page: 90 / 176

89
OPERATION
POWER TAKE-OFF (PTO)
WARNING: PTO shafts and PTO driven imple-
ments can be extremely dangerous. Observe
the following important points:
DO NOT operate tractor without a PTO cap
installed. The cap protects people from injury
as well as the splines from damage.
Before attaching, adjusting or working on
PTO driven implements, disengage the PTO,
stop the engine and remove the key. DO NOT
work under raised equipment.
Before engaging a PTO-driven implement,
ALWAYS carefully raise and lower the imple-
ment using Position Control. Check clear-
ances, PTO shaft sliding range and articula-
tion.
Ensure that all PTO safety shields are in
place at all times.
Ensure all PTO-driven implements are in
good condition and conform to current stan-
dards.
NEVER step across any driveline.
DO NOT use the tractor drawbar or the imple-
ment drawbar as a step.
NEVER use the driveline as a step.
NEVER wear loose fitting clothes.
Keep at least your height away from a rotat-
ing driveline.
Rear PTO Shaft
FIG. 5-62: A six-spline (35 mm) PTO shaft, 1, is pro-
vided at rear of Tractor to provide power for mounted
and other PTO driven equipment as required.
A protective cover is positioned over shaft splines
when not in use.
Normal rear PTO shaft operating speed.
540 rpm @ 2430 engine rpm
1000 rpm @ 2500 engine rpm
IMPORTANT: When rear PTO is used with three-
point mounted equipment, it may be
necessary to remove drawbar, 2, at
rear of Tractor. Some types of mount-
ed equipment, when lowered, may
allow PTO shaft to contact drawbar.
FIG. 5-63: Implement driveshaft shown connected to
tractor rear PTO shaft.
CAUTION: Make sure all PTO shields are
installed on Tractor and equipment. Before
cleaning or adjusting Tractor or PTO driv-
en machine, SHUT OFF ENGINE AND DIS-
ENGAGE PTO.
FIG. 5-63
1
2
FIG. 5-62