Iseki TG5330, Operation Manual

Page: 15 / 176

TG5330,5390,5470
14
When disconnecting the battery cables, disconnect the
earth cable (-) first without fail. When connecting the bat-
tery cables, connect the positive cable (+) first.
Disconnecting or connecting in wrong order may lead to a
short circuit or sparks.
TO HANDLE BOOSTER CABLES
When using booster cables, pay attention to the following
items for safe operation:
(1) Before connecting cables, remove the vent plugs.
This will lower the force in case of explosion.
(2) Before connecting cables, be sure to stop the engine.
Otherwise unexpected accidents may occur.
(3) Use booster cables with sufficient electrical capacity.
A cable of inadequate capacity will cause generation
of heat, which may lead to a fire.
SAFETY DECALS
The labels are stuck on the tractor. You should of course
read the safety instructions in the manual. But never fail
to read the labels on the machine as well.
・ The labels should always be clearly seen, that is,
nothing should obscure them.
・
When they have become dirty, wash them with
soap water and wipe off with soft cloth.
・ If any of them are torn or lost, order new labels
from your dealer. Their codes are mentioned in
SAFETY DECALS AND THEIR LOCATION .
・
A new label should be placed in the same place
where the old one was located.
・ When sticking on a new label, clean the place to
enable the label to stick and squeeze out all air
bubbles trapped under it.
FIG. 1-24
FIG. 1-25