Iseki TG5330, Operation Manual

Page: 30 / 176

29
INSTRUMENTS & CONTROLS
Fuel Gauge
FIG. 4-8: Gauge, 5, indicates level of diesel fuel in fuel
tank when main switch is ON
NOTE: Use only clean diesel fuel and clean area to pre
vent dirt/water entry into fuel tank when
refilling.DO NOT run out of fuel as bleeding air
from the system will be required. Keep fuel tank
full to minimize condensation.
CAUTION: DO NOT refill fuel tank with engine
running or hot. Allow cooling period. DO NOT
smoke near fuel tank. Clean up any spilled
fuel.
Horn / Light Turn Switch
FIG. 4-9: Horn / Light Turn Switch.
Horn Switch, 6 - Horn will sound when center switch but-
ton is depressed.
Light Switch, 7 - Is a rotary switch with three operating
positions:
・
OFF - Fully counterclockwise. All lights off.
・
1st - Low beam headlamps and rear tail lights.
・
2nd - Main (high) beam headlamps and rear tail lights.
NOTE: When high beam is selected (2nd position), light
in indicator light strip will come on.
Turn Switch, 8 - Operate switch handle in direction
Tractor is being turned. The appropriate flashing amber
warning light (ROPS-mounted) will operate as turn signal.
Return switch to center position to cancel.
NOTE: Turn lights will not self-cancel. Select turn/hazard
light switch to center position after completing
turn.
FIG. 4-10: Turn the position lamp switch, 9, to turn the
position lamps on.
Hazard Light Switch, - Press switch, 10, to turn on haz-
ard lights. Both flashing amber warning lights will operate
at the same time.
CAUTION: Hazard lights must be used any
time Tractor is driven on public roadway.
Consult local agencies for other marking
requirements.
5
FIG. 4-8
8
6
7
FIG. 4-9
10
9
FIG. 4-10