58
TG5330,5390,5470
Operator Observations
Constant attention should be paid to the following points
during operation:
・
Engine oil pressure lamp will come on in case of low
engine oil pressure. Stop engine immediately.
・
Battery charge lamp will come on if battery is not
being charged properly. Stop engine and investigate
cause.
・
Coolant temperature gauge needle will indicate
(hot) in case of overheated engine. Stop engine, allow
to cool and investigate cause.
・
Fuel gauge should not be allowed to
(empty) as
running out of fuel may result with need to bleed air
from fuel system.
CAUTION: DO NOT attempt to service Tractor
with engine running or hot. Allow to cool.
NOTE: Refer to Trouble-Shooting
when defect is indi-
cated, to assist locating problem.
Starting Circuit Operation
Tractor is equipped with a starting system to protect the
operator. To permit tractor to be started (start motor to
operate), ALL the following is required:
・
Shuttle Lever in Neutral
・
Rear PTO Switch in Off position.
WARNING: Safety switch system is installed
for your protection. DO NOT bypass or modi-
fy the safety start switch system. If the neu-
tral start switch system does not operate
properly as detailed above, contact your
Dealer immediately and have the system
repaired.
Periodically check that the starting circuit is functioning
correctly. The procedure for this is check is as follows:
1. Check that there are no bystanders around the trac-
tor should it inadvertently start.
2. Depress clutch and brake pedals. Attempt to start the
tractor with the gear shift levers and PTO control
switch OFF. The tractor should start.
3. Depress the clutch and brake pedals. Attempt to start
the Tractor with the gears engaged and the PTO
switch ON. The Tractor should NOT start.
4. Depress the clutch and brake pedals. Attempt to start
the tractor with the gears in neutral and the PTO
switch ON. The Tractor should NOT start.
If starting system is not working correctly it must be
repaired immediately by your Dealer.
The starter will rotate when not sitting in the seat, but the
engine will not start.
The engine will automatically stop about three seconds
after the operator leaves the seat. Do not leave the seat
while operating the tractor.
Summary of Contents for TG5330
