Iseki TG5330, Operation Manual

Page: 53 / 176

52
TG5330,5390,5470
THREE-POINT HITCH
Complete operating instructions for three-point hitch are
given in Operation section of this book.
Control Lever
FIG. 4-59: Position control lever, 1, adjusts height of
three-point hitch on rear of Tractor. Setting lever in a par-
ticular position will set the height respectively. Full up
position is with lever fully rearward and full down position
is with lever completely forward.
Draft control lever, 2,(except for HST type) adjusts height
of three-point hitch according to the draft or pull of
ground-engaging implements This provides conststent
load on Tractor and provides weight transfer to Tractor
rear wheels to reduce wheel slippage.
Lever stops, 3 and 4, can be adjusted within slot to limit
implement raising/lowering.
CAUTION: use position control lever, 1, when
attaching or detaching implements.
NOTE: When starting engine, ensure implement is low-
ered to the ground and both levers are fuly for-
ward. This reduces load on starter due to hitch
trying to raise when engine is cranked.
Lowering Rate Control Knob
FIG. 4-60: Lowering rate knob, 1, adjusts rate of drop of
three-point hitch and implement. Turning knob clockwise
will increase lowering time and counterclockwise will
decrease lowering time. Turning knob fully clockwise will
lock implement (or hitch) in raised position for transport.
CAUTION: When working near or under
mounted equipment, securely block in posi-
tion and turn lowering rate clockwise to
stop .
4
2
1
3
FIG. 4-59
FIG. 4-60