Iseki TG5330, Operation Manual

Page: 166 / 176

ASSEMBLY & PRE-DELIVERY INSPECTION
165
7. Front Bumper — Install front bumper and secure with
four bolts supplied in sundry box.
8. Rear Lights — Install red lights at rear of fenders. The
hardware and wiring retainer straps are installed on
the light for shipment.
After attaching light, attach electrical connectors to con-
nectors located at fender and ROPS support.
Green wire with white stripe will attach to red wire with
black stripe. Black ground wire will attach to orange wire
with black stripe.
9. Warning Flashers — Install amber turn / warning lights
to fenders as follows:
a. Remove nut, internal lock washer and ground wire
from light.
b. Insert bolt with center wire down through hole in
ROPS bracket and reinstall ground wire, internal
lock washer and nut. Tighten nut.
c. There are three wires, with single connectors, com-
ing out at top rear of ROPS, support. Two wires are
the same length. They attach to wires from warning
/ flasher light. Male and female couplers prevent
improper installation.
d. The remaining connector is used if a work light or
radio is installed.
10.Seat — Remove bolts from seat frame and install seat
using same hardware.
11.Three-Point Hitch — Three-point hitch is partially
assembled, with lift links attached at the top to the lift
shaft, and away chains attached to the lower links.
a. Attach lower links to Tractor attaching points and
secure with lynch pins. Lower links will flare out
ward t rear and retaining rings for spring will locate
at underside.
b. Connect clevis end of check chains to axle brack-
ets and secure with clevis pin and cotter pin.
c. Remove bolts at lower end of lift links and attach lift
links to identical positions on lower links using bolts,
lock washers and nuts removed. Lift link with turn-
buckle adjustment is located on right side.
IMPORTANT: Bolts should be installed with heads to
out-side (nuts on inside) of lift link, to pre-
vent tire interference during operation.
d. Connect top link to anchor point on Tractor using 19
mm x 220 mm pin and lynch pin. Lock nut on top
link barrel will locate to rear. Store top link imple-
ment pin (19 mm x 86 mm) and clip in rear end of
top link.
e. Connect spring to retaining rings at underside of
lower links.
12.Drawbar — Install drawbar fully into bracket at rear of
Tractor and secure with pin and clip provided.
13.Front Wheels —
a. Carefully raise and block front of Tractor.
b. Install wheel / tire assemblies and secure using
bolts and lock washers. Tighten to 75 ft-lbs. (102
Nm).
c. Remove blocking and lower front of Tractor.
14.Rear Wheels —
a. Carefully raise and block rear of Tractor at each
side to prevent pivoting of front axle.
b. Install wheel / tire assemblies and secure using lock
washers and bolts. Tighten to 80 ft-lbs. (120 Nm).
15.Steering Wheel — After wheels have been installed,
place front wheels in a straight forward position.
a. Remove cotter pin, nut and flat washer from steer-
ing wheel shaft.
b. Use a screw driver or flat blade to pry between
steering wheel and cap to remove cap.
IMPORTANT: Don t use a punch through hole in steer-
ing wheel to remove cap. It will separate
the emblem from cap.