Intermec 502O, User Manual

Page: 310 / 402

5020 Data Collection PC User’s Manual nuggetf
code39
9-8
Problems While Configuring the 5020 (continued)
Problem or Message Solution
You want to set certain parameters back to the
factory default.
1. Open the Configuration application on the 5020 or the remote Unit
Management application on your host PC. For help, see Chapter 3,
“Configuring the 5020.”
2. Go to the screen for the parameters you want to change.
3. Press
3 to put the focus on the Defaults button and press & or
click on the Defaults button.
4. Press
3 to put the focus on the Apply button and press & or click
on the Apply button.
5. Press
& or Enter at the prompt.
6. Exit the Configuration application or Unit Management.
You scan a configuration command, such as
Beep Volume Very Quiet, and nothing
happens. There are two possible solutions:
•
If you are working in the Configuration application, you cannot
scan configuration commands. Use the Configure menu to change
the 5020’s configuration, or exit the Configuration application to
scan configuration commands.
•
The 5020 may be waiting for another command to complete the
configuration change. If you started by scanning the Enter
Accumulate command, you must finish the command by scanning
the Exit Accumulate command. For help, see Chapter 8,
“Configuration Command Reference.”
You scan a configuration command, such as
Beep Duration, and you hear three low beeps. You scanned an invalid configuration command. Make sure the variable
(data) part of the command is valid for that command. For example, the
beep duration cannot be lower than 10 ms, so the following
configuration, which would set the duration to 5 ms, would be invalid.
Invalid Beep Duration (5 ms)
*$+BB5*
*$+BB5*
You choose Data Collection from the
Configure menu in the Configuration
application or Configuration from the remote
Unit Management and some or all of the
parameters do not display or show as Not
Available. You may not have waited for the warm or cold boot to finish before you
opened the Configuration application. Choose Refresh to refresh the
parameters. On a warm or cold boot, wait until the beep sequence (three
high beeps and one low beep) sounds before you open any applications.