Intermec 502O, User Manual

Page: 198 / 402

5020 Data Collection PC User’s Manual
N
ugg
Co d e 39
7-4
When you exit Accumulate mode, the accumulated data is “entered” as a data record.
Up to 250 characters can be held in the buffer. If the data record count exceeds 250
characters, the data is truncated. If you reset the 5020 (software or hardware reset), you
exit Accumulate mode, the entire buffer is cleared, and all data accumulated is lost.
To use Accumulate mode
The syntax to use the Enter Accumulate command is:
+/ data
where:
+/ is the syntax for the Enter Accumulate mode command.
data is the optional data you want to enter. Data can be a reader command that is
executed when you exit Accumulate mode.
1. Scan this bar code label to Enter Accumulate mode:
Enter Accumulate Mode
*+/*
*+/*
2. Scan the bar code label(s) for the data you want to enter. You can scan labels from
the “Full ASCII Bar Code Chart” in Appendix B.
For example, scan this label to change the 5020’s configuration and set the
preamble to the characters XYZ.
Change Configuration / Set Preamble to XYZ
*$+ADXYZ*
*$+ADXYZ*
Or, to edit the accumulated data, scan one of these bar code labels:
Clear Enter
*--* **
*- -* **
Note: You can create one bar code label by combining Steps 1 and 2 above. Most
of the examples in this manual use one bar code label.
3. Scan this bar code label to exit Accumulate mode and enter the data record.
Exit Accumulate Mode
*-/*
*-/*