Intermec 502O, User Manual

Page: 212 / 402

5020 Data Collection PC User’s Manual Nugg
Co d e 39
8-10
Acknowledgement Delay Upper Limit (continued)
Configuration: Use one of these methods:
Configuration
Applications
SNMP Bar Codes
Yes Yes No
In the Configuration or Unit Management application, choose Configure and then
Network. Next, choose Protocols, then UDP Plus, and finally choose Ack Delay Upper
Limit. For help, see Chapter 3, “Configuring the 5020.”
On Cold Boot: Not saved
SNMP OID: 1.3.6.1.4.1.1963.5.15.20.1.1.1.3.1
Options: Acceptable values for the upper limit are any number from 2 to 60 seconds.
Default: 5 seconds
Automatic Shutoff
Purpose: Defines the maximum length of time the 5020 remains on when there is no activity.
When you do not use the 5020 for the length of time set with this command, the
computer automatically turns off as if you had pressed
' to turn it off.
When you press
' to turn on the 5020, the PC either resumes exactly where it was
when you turned it off or the 5020 boots and restarts your application.
You can use the Configuration application, the Unit Management application, or the
Power applet in the Control Panel to set the Automatic Shutoff parameter. In the
Configuration and Unit Management applications, the value you set will turn off the
5020 when you are using it on battery power.
In the Control Panel, you can set separate values to turn off the 5020 when it is on
battery power or on AC power. If the 5020 is connected to AC power through the
D5020 or L5020, automatic shutoff is disabled unless you enable the suspend while on
external power in the Control Panel Power applet. For help, see Chapter 4,
“Customizing the 5020 Using the Control Panel.”
Power Management Tip: You should use the Automatic Shutoff feature to preserve
the main battery pack’s power.