Intermec 502O, User Manual

Page: 241 / 402

Nugg
Co d e 39
Configuration Command Reference
8-39
8
Scan: One of these bar codes:
Low Decode Security
*$+CS0*
*$+CS0*
Moderate Decode Security
*$+CS1*
*$+CS1*
High Decode Security
*$+CS2*
*$+CS2*
Default Router
Purpose: Defines the IP address assigned to the default router in your RF or Ethernet network.
The router provides a software and hardware connection between two or more networks
that permits traffic to be routed from one network to another on the basis of the
intended destinations of that traffic.
When the DCS 300 or host is on a different subnetwork than the 5020, you need to set
the IP address assigned to the default router. The 5020 uses the router address to send
packets across the network to the DCS 300 or host. The default of 0.0.0.0 means there
is no default router. After you change this parameter, suspend and resume the 5020 to
make the change effective.
Configuration: Use one of these methods:
Configuration
Applications
SNMP Bar Codes
Yes Yes No
In the Configuration or Unit Management application, choose Configure and then
Network. Next, choose Radio or Ethernet, then IP Address, then Obtain IP Address Via
DHCP, and finally choose Default Router. For help, see Chapter 3, “Configuring the
5020.”
On Cold Boot: Saved
SNMP OID: 1.3.6.1.4.1.1963.5.15.2.1.4.index
where index is the radio or I/O adapter card number.