Intermec 502O, User Manual

Page: 257 / 402

Nugg
Co d e 39
Configuration Command Reference
8-55
8
Postamble
Purpose: Sets the postamble that is appended to any data you scan with the 5020. Common
postambles include cursor controls such as tabs or carriage return line feeds.
Configuration: Use one of these methods:
Configuration
Applications
SNMP Bar Codes
Yes Yes Yes
In the Configuration or Unit Management application, choose Configure and then Data
Collection. Next, choose Virtual Wedge and finally choose Postamble. For help, see
Chapter 3, “Configuring the 5020.”
On Cold Boot: Not saved
SNMP OID: 1.3.6.1.4.1.1963.15.3.2.1.1.4.1
Syntax: AEdata
You only use the two-character command AE for bar code configuration labels.
Acceptable values for data are up to 31 ASCII characters. Embedded null (<NUL>)
characters are not allowed. If you enter the AE command without data, the postamble is
disabled. If you are entering quotation marks as data or grouping configuration
commands, you need to enclose the data within quotation marks (see the example).
Note: To scan a bar code label that includes quotes, you must configure the 5020 to use
Code 39 in Full ASCII mode. For help, see “Code 39” earlier in this chapter.
Default: Tab character (\t)
Scan: To disable the postamble, scan this bar code:
Disable Postamble
*$+AE*
*$+AE*
Or: To set the postamble to an ASCII character string:
1. Scan this bar code:
Enter Accumulate Mode / Set Postamble
*+/$+AE*
*+/$+AE*