Intermec 502O, User Manual

Page: 216 / 402

5020 Data Collection PC User’s Manual Nugg
Co d e 39
8-14
Beep Frequency
Purpose: Defines the individual frequencies of the 5020 beeps. There are two types of beeps:
•
Low beep
•
High beep
Configuration: Use one of these methods:
Configuration
Applications
SNMP Bar Codes
Yes Yes Yes
In the Configuration or Unit Management application, choose Configure and then Unit.
Next, choose Speaker and then choose either Low Beep Frequency or High Beep
Frequency. For help, see Chapter 3, “Configuring the 5020.”
On Cold Boot: Not saved
SNMP OID: 1.3.6.1.4.1.1963.15.3.1.4.1.4.1 Low beep frequency
1.3.6.1.4.1.1963.15.3.1.4.1.5.1 High beep frequency
Syntax: BGdata Low beep frequency
BHdata High beep frequency
You only use the two-character command BG or BH for bar code configuration labels.
Acceptable values for data are from 100 to 20,000 Hz (20 KHz).
Note: If you set the frequency outside the range of 100 Hz to 10,000 Hz, the beeps are
inaudible.
Default: 1000 Hz for the low beep
2300 Hz for the high beep
Scan: 1. Scan this bar code:
Enter Accumulate Mode
*+/*
*+/*
2. Scan one of these bar codes:
Change Low Beep Frequency Change High Beep Frequency
*$+BG* *$+BH*
*$+BG* *$+BH*