Intermec 502O, User Manual

Page: 106 / 402

5020 Data Collection PC User’s Manual
39
jjj
Helveticcond blk
3-30
6. Choose Controller IP Address and set the IP address of the DCS 300. You can set
other UDP Plus parameters as needed.
Use the
3 (Tab) key and the cursor keys to navigate in the configuration screen.
For help, see “Navigating in the Configuration Application” earlier in this chapter.
7. To save your changes, press
3 to select the Apply button and then press &.
8. Press
$ 3 three times to select Advanced. The Advanced configuration screen
appears.
9. Press
3 and then ! to select the UDP Plus Enable parameter.
10. Press
3 to move to the UDP Plus enable check box and then press 4 to enable
UDP Plus.
11. To save your changes, press
3 to select the Apply button and then press &.
12. Press
" to exit the Configuration application.
13. Press
! to highlight Exit and then press &.
14. Warm boot the 5020 to enable UDP Plus protocol. For help, see “Booting the 5020”
in Chapter 9.
After you have configured the 5020 for a UDP Plus network, a icon appears and
remains on in the Notification Tray indicating that the 5020 is communicating with the
DCS 300. If you do not see a
icon or it is blinking, see Chapter 9, “Troubleshooting,”
for help.