Page 46
EN
Chapter 13 Dismantling and disposal
13 Dismantling and disposal
After the machine’s period of use has expired, the machine
must be dismantled and sent for environmentally conscious
disposal.
13.1 Safety
• Only task trained or instructed staff with dismantling the
inoCOMB Maxi Power.
• Work on the electronic control system may only be per-
formed by a qualified electrician.
WARNING
Risk of injury posed by improper disas-
sembly.
Stored residual energy, sharp components, points and
corners on and in the machine can cause injuries.
• Ensure there is enough space for disassembly.
• Wear gloves and safety boots to avoid injuries.
• Handle sharp-edged parts with care.
• Ensure that the workplace is tidy and clean. Loose com-
ponents and tools lying around or on top of each other
can cause accidents.
• Adopt good practice when dismantling the components.
• Note that some individual parts may be very heavy.
• Secure the individual parts to ensure these do not fall
down or topple over.
• In the event of uncertainty, call the INOTEC service hotline
on +49 7741 6805 777.
!
DANGER
Electrical voltage
Danger of death due to electric shock.
When switched on, electrical components can cause
uncontrolled movements and lead to serious injury.
1. Switch the machine off. To switch on, turn the red rotary
switch to the vertical position “0”.
2. Pull out the mains plug and finally disconnect the ma-
chine from the electrical supply.
13.2 Dismantling
Clean and dismantle the machine before sorting the parts
in compliance with the applicable occupational health and
environmental protection regulations.
13.3 Disposal
According to European Directive 2012/19/EU on waste
electrical and electronic equipment and its implementation
in national law, this machine should not be disposed of in
general household waste, but recycled in an environmental-
ly conscious manner!
The inoCOMB Maxi Power primarily of high-quality
metal. Observe the following if you are decommis-
sioning the inoCOMB Maxi Power for the final time:
• Send the metal to a recycling facility.
• Dispose of the inoCOMB Maxi Power via a scrap metal
dealer or your local scrap metal collection centre.
Your used INOTEC equipment will be taken back by us and
disposed of in an environmentally conscious manner. Please
contact one of our service centres to arrange this.
