Page 38
EN
Chapter 7 Commissioning
7 Commissioning
7.1 Adding material to the material hopper
Warning
Risk to health due to dust.
When filling and cleaning the machine, inhaled dust
can cause long-term lung damage or other adverse
health effects.
• The machine operator or people working in the dust area
must each wear a dust mask when cleaning the machine.
• Find out about the technical rules for hazardous sub-
stances (TRGS 559) “Mineral dust” on the homepage
of the German Social Accident Insurance Institution
(www.bgbau.de).
Warning
Risk of injury posed by powdery and paste-
like material
When adding bagged goods to the material hopper, swirl-
ing or splashing material may pose a risk of injury, espe-
cially in the region of the eye and face.
• Always wear safety goggles.
7.2 Opening and emptying bags of material
Warning
Observe the applicable occupational safety
regulations (e.g. respiratory protection)
To clean the bags of material, proceed as follows:
1. Place the bag of material on the hopper mesh with the
tooth rail.
2. Tear open the bag of material by using short forward and
backward movements.
3. Move the bag sideways and upwards and then empty
the contents into the material hopper.
4. Observe the applicable occupational safety regulations
(e.g. respiratory protection, etc.).
5. Dispose of the empty bags of material and other pack-
aging material in an environmentally friendly manner in
accordance with the instructions provided by the packag-
ing manufacturer.
7.3 Changing material
1. Run the material hopper of the inoCOMB Maxi Power
until it is empty.
2. Then switch off the mixing pump and compressor.
3. Close the valve on the external water supply.
4. Clean the material container, mixing coil, mixing zone
and pump unit (rotor/stator/pressure gauge) incl. the
conveyor hoses used.
!
WARNING
Operation without any material or with
too little material.
Danger of destroying the rotor/stator.
If the machine is operated without any material or with too
little material, there is a risk of the rotor/stator being de-
stroyed within an extremely short period of time (< 1 min.)!
7.4 Change of location on the construction site
The inoCOMB Maxi Power is equipped with four wheels.
Convenient handles are fitted at all four corners for moving
the whole machine.
To do this, disconnect the mixing pump from the electricity
and water supply.
