Page 43
EN
Chapter 12 Faults, causes and solutions
12 Faults, causes and solutions
The inoCOMB Maxi Power is designed for fault-free oper-
ation. However, should a fault occur, please follow the in-
structions below on analysing, checking and remedying the
fault or contact the Inotec Service team (see the address list
for INOTEC service centres at the end of the document) or
call the INOTEC service hotline on: +49 7741 6805 777.
WARNING
Faults can put
the safety of operating staff at risk and impair the
functionality of the machine.
Proceed as follows where a fault occurs:
1. Cut off the power supply in the event of any faults
which pose a direct risk to people or material assets. To
do this, press the red pushbutton.
2. Pull out the mains plug.
3. Secure the machine against unexpectedly being
switched back on
4. Determine the cause of the fault.
5. Report the fault to the responsible person on site.
6. Depending on the type of fault you can either rectify
this yourself or have it rectified by a qualified electrical
specialist.
The faults listed below feature recommendations as
to who is authorised to rectify the fault.
