Page 8
EN
Chapter 2 Safety
2.3 Notices on the machine
!
DANGER
Safety notices on the machine make oper-
ating staff aware of imminent danger.
The following warning notices are affixed to the inoCOMB
Maxi Power:
Instructions on the mixed zone:
• Pressurised parts! Depressurise the machine before any
cleaning or maintenance work (1).
Instructions on the switching cabinet:
• Switch off the main switch before opening the switching
cabinet housing (2).
• Read the operating instructions carefully before starting
work (3).
• Caution: live parts! Disconnect the mains plug before
carrying out any work (4).
• Incorrect direction of rotation (5)
• The device may only be operated via a connector protect-
ed with an RCD (FI) I
Dh
≤ 30 mA (sticker on the side of
the switching cabinet below the feeder).
Note on the four fold-out carrying handles:
• If a lifting device is used for transport, the attachment
points provided and marked for this purpose must be
used.
Instructions on the material hopper (6):
• Caution: rotating parts! Do not carry out any mainte-
nance or cleaning work with the machine running or
the protective cover removed.
Other notes:
• If there is a risk of frost, drain the water (see water fit-
ting).
Observe all the safety and hazard notices that are attached
to the machine. Always keep the safety and hazard notices
in a clearly legible condition.
1
3
4
5
5
6
2
2.2.3 Conversions and changes
!
DANGER
Conversions or changes can put the safe-
ty of operating staff at risk and impair the functional-
ity of the machine.
• Do not make any changes, additions or conver-
sions to the machine without first consulting
Inotec GmbH and obtaining its written approval. Other-
wise, the operating license will become void.
2.2.4 Cleaning and maintaining the machine
!
WARNING
Cleaning and maintenance work can put
the safety of operating staff at risk and impair the
functionality of the machine.
1. Switch off the machine and pull out the mains plug.
2. Secure the machine against unexpectedly being
switched back on.
3. Before cleaning with the water jet, cover all the open-
ings that water must not penetrate into for safety and
functional reasons.
4. After cleaning, remove all the covers which were at-
tached to protect against the water.
2.2.5 Changing the location of the machine
The inoCOMB Maxi Power is equipped with four wheels.
Convenient handles are fitted at all four corners for moving
the whole machine.
!
CAUTION
Changing location can put the safety of
operating staff at risk and impair the functionality of
the machine.
1. Switch off the machine and pull out the mains plug.
2. Move the machine to a new location on the building
site.
3. Always install the machine in such a way that it is level
and stable.
4. Secure the machine against undesirable movements.
