Page 10
EN
Chapter 4 Assembly and function
3.3 Water measuring system
Pressure being too low
min. 2.5 bar
Pressure reducer
ex-works setting
2.0 bar
Solenoid valve
42 V
Supply line
¾ inch water pipe
(to be supplied by cus-
tomer)
3.4 Material hopper
Fill quantity
max. 145 l
3.5 Pump motor
Output/rotation speed
5.5 kW, 419 U/min
-1
Installation position
Motor vertical
Electrical data
f = 50 Hz, I = 11.1 A,
U = 400 V, IP 55
Insulation class
F, ED = S1
Colour
Black
3.6 Star feeder motor
Output/rotation speed
0.55 kW, 29 rpm
Installation position
Motor horizontal
Electrical data
f = 50 Hz, I = 1.5 A,
U = 400 V, IP 55
Insulation class
F, ED = S1
Colour
Black
3.7 Rotor/stator
D6-3
Standard
D4 1/4 output
D4 1/2 output
D6-3 Helix
R7 - 1.5
D8-1.5
D8-2
Depending on the
material
3.8 Noise emissions
Sound power level LWA
80 dB (A)
3.9 Operating conditions
Temperature range
2 - 45 °C
Relative humidity, maximum
80 %
4 Assembly and function
4.1 Scope of delivery of inoCOMB Maxi Power set
(Item no. 10044216)
The scope of delivery is generated using the components
ordered and can be checked using the delivery note.
• Frame, reinforced version
• 4 running wheels
• Material hopper (galvanised)
• Geared motor (with reinforced axial bearing)
• Rotor/stator D 6-3
• Switching cabinet
• Mortar pressure gauge
• Compressor
• Mixing coil
• Water fitting
• Water pump
• Mortar hose Ø 25 mm, 10 m
• Air hose, Ø ½”, 15 m
• Tool set
• Straight finishing coat device incl. nozzle with a
diameter of 14 mm
• Assembly, spray lubricant
• Operating manual
4.2 Functionality
The mixing pump is filled with powdery material, for in-
stance, bagged goods. The mixing coil and pump unit (ro-
tor/stator) are directly driven by a gear motor. During oper-
ation, the powdered material is conveyed from the material
hopper over the star feeder into the mixing zone, − where it
is mixed with water with the mixing coil − to form a homo-
geneous, paste-like product. The pump unit (rotor/stator)
attached at the lower end of the mixing zone conveys the
mixture through flexible conveyor hoses to the spray gun
or glue gun. The machine is controlled either pneumatically
(via the air valve on the spraying device or electrically via a
remote control cable laid from the switching cabinet to the
spraying device. Here, the machine is controlled by an on/
off switch.
NOTE
If the machine control is to be changed
from electric to pneumatic, the dummy plug must be
plugged into the Harting plug of the switching cabi-
net.
