Page 36
EN
Chapter 6 Installation
6.10 Setting the water quantity
Use the flow regulator to control the desired water flow.
1
2
You can read the current flow rate on the inspection glass
of the flow meter (1). With the fine adjustment valve (2)
you can regulate the fine setting for the desired
material consistency. Follow the instructions of the
manufacturer of the drying material.
!
CAUTION
If the amount of water is too low,
the conveyor hose in which the mixed materi-
al is conveyed to the sprayer can become blocked.
This can lead to severe wear of the pump unit
(rotor/stator). It is therefore advisable to start with
plenty of water so that the amount of water can then
be reduced to the required level.
6.11 Regulating the water pressure
A pressure reducer is installed and pre-set at the factory to
regulate the water pressure. The control cap on the pres-
sure reducer allows you to readjust the water pressure if
necessary.
6.12 Material preparation
Fill the material hopper with dry material.
!
CAUTION
Make sure that no bag parts fall into the
material hopper when emptying the dry material.
These would mix with the material and could clog the
sprayer, causing severe damage to the machine.
NOTE
Fill the mixing zone with water before
starting the machine.
1. Press the “Water” push button(1) on the switching
cabinet.
2. Then set the “star feeder selector switch” (2) to auto-
matic.
3. Turn the main switch (3) to the vertical position (“ON”).
4. Press the green start button “I”.
1
2
3
4
!
WARNING
Machine does not start. Check the posi-
tion of the main switch on the switching cabinet and
all electrical connections. In the event that all connec-
tions are correct and the main switch is in the ver-
tical position (“ON’) and the pump motor still does
not rotate, have the machine checked by a qualified
electrician. Only this person is authorised to open the
switching cabinet.
