Page 39
EN
Chapter 8 Operation, use
8 Operation, use
8.1 Checking operating performance
1. If you notice any deviations in the operating behaviour,
decommission the inoCOMB Maxi Power immediately.
2. Ensure that the damage and/or defects which led to the
deviating operating behaviour are rectified.
8.2 Checking the consistency of the material
Ensure an even, paste-like material consistency during
operation.
• The viscosity may change, especially in warm weather
conditions.
Material too rigid
Increase the water supply
by re-adjusting it on the
needle valve of the water
fitting
Material too runny
Reduce the water supply by
re-adjusting it on the nee-
dle valve of the water fitting
NOTE
Ensure that the change in consistency
may take some time to become noticeable, depend-
ing on the length of the hose (approx. 20 seconds per
15 m hose length). Therefore, adjust the water supply
at the needle valve only by turning it a small amount
each time.
8.3 Correcting flow fluctuations
1. Check the water inlet screen and clean it if it is dirty.
2. Check the water pressure at the supply line and regulate
it accordingly, if necessary.
3. Check the pressure reducer and regulate it, if necessary.
8.4 Work break/end of work
If the duration of a work break exceeds the setting time of
the material to be processed, there is a risk of the material
setting during the break.
1. In the event of short interruptions of the pump process
(up to approx. 15 min., depending on the material),
close the air valve and the material valve on the spray-
ing device.
2. In the event of longer interruptions, the machine must
be run until it is empty and then cleaned.
9 Areas of application
inoCOMB Maxi Power
Floor filling compounds
P
Fire protection mortar
P
Floating screeds
P
Lime-based finishing plasters
P
Lime plasters
P
Lime cement plasters
P
Machine-applied gypsum plasters
for indoor applications
P
Mineral textured plasters
P
*
Renovating plaster systems
P
*
Spray-on filling compounds
P
ETICS glue, mineral
P
Cement plasters
P
It is essential that the information the manufacturer has provided about the material be
observed!
* Pre-mixed material (paste-like)
