Page 12
EN
Chapter 4 Assembly and function
4.3.1.1 Frame with wheels, material hopper, star feed-
er and star feeder motor
The material hopper, switching cabinet, the mixing pump
unit with mixing zone and motor as well as the air and wa-
ter fittings are assembled on the frame. The star feeder is
fixed under the protective grid of the material hopper.
Material hopper with star feeder
4.3.1.2 Mixing pump unit (mixing zone with mixing
coil, rotor / stator and mortar pressure gauge)
To insert the mixing coil, open the lateral locking device of
the tilting flange and fold down the motor sideways. De-
pending on the area of application, various rotors and sta-
tors are used (see accessories).
Lateral locking of the tilting flange with eccentric lock
4.3.1.3 Pump motor
The motor is attached to the material hopper with an ec-
centric lock. The power supply for the motor is plugged into
the switching cabinet.
4.3.1.4 Switching cabinet
All the necessary connections and controls for operating the
machine are located on the switching cabinet. It is firmly
screwed to the frame of the machine. The switching cabinet
can be removed from the frame for maintenance and repair
work.
Connect the power supply plug on the switching cabinet to
the external power supply (400 V / 50 Hz). The cross-sec-
tion of the supply cable is at least 4.0 mm
2
at 400 V
3 PH! The inoCOMB Maxi Power may only be run with an
approved FI circuit breaker (30 mA) (RCD).
4.3.1.5 Water fitting
The water fitting is attached to the frame. The optimum
water supply quantity is set by opening and closing the nee-
dle valve.
4.3.1.6 Air fitting
The air fitting is attached to the frame. It is connected to the
compressor, which stands on a support frame at the front
of the machine.
4.3.1.7 Compressor
A compressor will be required if the mixing pump is to be
used for spray applications. This is located at the front on
a support frame that is connected to the base frame. The
compressor is protected from dust and splash water with a
rubber mat.
