Page 31
EN
Chapter 6 Installation
5.6 Transport of the used machine in vehicle
!
DANGER
Slipping machine.
Danger of death for drivers and transport users.
1. Ensure that the machine is stored securely during trans-
port.
2. Secure the machine against slipping.
3. Choose a means of transport that has sufficient load
capacity.
NOTE
Leaking material residue
• Clean the machine before transport.
• Secure the machine in the vehicle using suitable fixing
materials.
5.7 Storage
If the machine is not likely to be used for an extended
period of time, thorough cleaning will be required.
Store the machine under the following environmental
conditions:
• Dry
• Frost-free
• Protected from dust
• Protected against corrosion (e.g. salt water)
6 Installation
Observe the following notices when assembling and posi-
tioning the machine:
!
DANGER
If the inoCOMB Maxi Power is operated
by unqualified individuals, this could put the life and
health of the operating staff at risk and cause prop-
erty damage to the inoCOMB Maxi Power or other
assets.
!
DANGER
Rotating mixing shafts.
Danger of death due to being pulled into the ma-
chine and crushed.
When the motor is running, the mixing shaft rotates
in the mixing zone!
• Do not reach into the rotating mixing shaft.
• Do not place any objects into the rotating mixing shaft.
1. Before working on the metering and mixing shaft, inter-
rupt the external power supply (main switch off).
2. Pull out the mains plug.
3. Secure the machine against unexpectedly being switched
back on.
4. Open the eccentric lock on the motor and move it away
to the side.
!
DANGER
Pressurised conveyor hoses.
Risk of injury and risk of property damage due to es-
caping and/or flying material, and/or bursting con-
veyor hoses.
• Before disconnecting the conveyor hoses, make sure that
the hoses are depressurised. To do so, check the pressure
indicator on the mortar pressure gauge. The pressure in-
dicator must display 0 bar!
• Before opening the hose coupling, let the
inoCOMB Maxi Power run in reverse to reduce any pres-
sure! To do this, turn the phase-change switch (1) until
the red illuminated button on the machine’s switching
cabinet (2) lights up. Then press the red illuminated but-
ton. The pump then runs backwards.
1
2
