INIM Electronics SmartLiving 10100L, User Manual

Page: 13 / 48

User’s Manual
The SmartLiving System 13
The list of faults signaled on the yellow fault LED can be found in the table in
Appendix C, Fault signals .
Following is the list of events which cause the Red System Alarm LED to
blink:
•
Open panel tamper
• Dislodged panel tamper
• Expansion tamper
• Keypad Tamper
• Reader Tamper
• Expansion Loss
• Keypad Loss
• Reader Loss
• False key
“FALSE KEY”
If the “False key” event is configured as a “Silent event”, the red LED will not
blink.
“50131STATHIDDEN”
If this option is enabled, the status of the partitions will be hidden. If a valid code
is entered at a keypad, the real-time status will be indicated on the keypad
concerned for 30 seconds. Additionally:
•
If the partitions are armed, the status of the system will be hidden from non-
authorized users.
•• Red keypad LED Off
•• Yellow keypad LED Off
•• Green keypad LED On solid
•• Status icons not present
•• Alarm and Tamper memory hidden
•• If a particular event occurs more than 5 times when the partitions are
armed, it will not be signaled as having occurred more than 5 times. This is
due to the limitation placed on the counter of each event. The counters will
reset to zero each time all the partitions are disarmed.
• If the partitions are DISARMED:
•• LEDs operating normally.
•• Status icons present
•• Alarm and Tamper memory visible
2-3-6
Signaling on the Buzzer
The buzzer signals the running Entry, Exit and Pre-arm times (refer to Appendix
A, Technical terminology and Glossary ) of enabled partitions.
2-3-7
Emergency status
In the event of a keypad configuration or communication error between the
system peripherals, the display will show one of the templates opposite.
If this occurs, you must contact your installer immediately and get the fault
cleared.
Buzzer signal Description
8 pulses with 5 second pause Entry time
3 pulses with 5 second pause;
4 short pulses with 5 second pause during the
final 20 seconds of the Exit Time
Exit time
1 pulse with 5 second pause Pre-arm time
- JOY/MAX -
FW RELEASE 3.00
NO COMMUNICATION
K01 P14
- JOY/MAX -
FW RELEASE 3.00
NOT ENROLLED
K01 P14