INIM Electronics SmartLiving 10100L, User Manual

Page: 20 / 48

20 Shortcuts
User’s Manual
3-2
Shortcut with code
Besides the keypad shortcuts provided by keys , each
user code can have as many as 22 customized (personal) shortcuts.
Users can access their code-shortcuts only after entering their PINs and pressing
(refer to paragraph 2-5-1 Accessing the User Menu ). Each code can be
programmed to manage:
• Up to 12 shortcuts activated by keys , ..., and identified by explicit
icons.
• Up to 10 shortcuts activated by keys , ..., . If a code is enabled to
operate the system over-the-phone, these shortcuts will also be available on
the telephone number-keys.
Entry of a code associated with shortcut no.9: at a JOY/MAX keypad, prompts
the voice announcement of all the shortcuts assigned to the number keys.
To activate a shortcut at a keypad, work though the following steps.
1. Type in your code then press .
2. Access the User Menu, using the method described in paragraph 2-5-1
Accessing the User Menu at point 2.
3. Press the key , ..., which corresponds to the shortcut icon or
press the key , ..., which is assigned directly to the shortcut.
To activate a shortcut over-the-phone:
1. Establish communication with the control panel.
2. Type in your code followed by “
# ”.
3. Listen to the voice prompts regarding the available shortcuts.
4. Press the number key which corresponds to the required shortcut.
3-3
Key and Reader shortcuts
3-3-1
nBy/S and nBy/X Reader shortcuts
Hold a valid key in the vicinity of the reader, as soon as the reader accepts the
key, a series of visual signals on the reader LEDs will indicate the various
shortcuts.
When the required shortcut is indicated, remove the key to activate the
corresponding shortcut action.
The visual signals on the Reader LEDs are as follows (refer to Table 7: Reader
LEDs with key at reader ).
1. Red LED on for 3 seconds - shortcut associated with the red LED of the
reader or first shortcut of the key
2. Blue LED on for 3 seconds - shortcut associated with the blue LED of the
reader or second shortcut of the key
3. Green LED on for 3 seconds - shortcut associated with the green LED of
the reader or third shortcut of the key
4. Yellow LED on for 3 seconds - shortcut associated with the yellow LED
of the reader or fourth shortcut of the key
5. All LEDs on for 3 seconds - first shortcut associated with the user key
6. All LEDs off for 3 seconds - disarm all the partitions.
7. If the key is not removed, the reader will run through the entire sequence
again starting from the red LED. Selection of the desired shortcut (indi-
cated by a specific LED) will not occur until the key is removed.
If, during this phase, any of the partitions are armed, the LED sequence will start
at point 6.
If the installer has enabled option “50131ReadLedOFF”, the reader LEDs will be
off, therefore, if you wish to activate a shortcut, you must:
1. Wave the key across the sensitive area of the reader: the LEDs will signal
the respective status for 30 seconds.
2. During this 30 second period, hold a valid key in the vicinity of the reader
in order to generate the visual signals on the reader LEDs. Remove the key
when the required operation or pre-set scenario is indicated on the LEDs.