INIM Electronics SmartLiving 10100L, User Manual

Page: 31 / 48

User’s Manual
Using the system 31
5-7
Change date and
time
This option allows you to set the date and time in accordance with the selected
format.
Via Keypad
Method 1
Activate the “Set date/time" shortcut (shortcut n.35: ) associated with one
of the following keys to shown on the display, with or without code entry, to
access the User Menu at the “Set date/time" section.
1. Use keys and to select the programming field (hour, minutes, etc.).
2. Use keys and to change the value in the selected field.
3. Press to save the setting.
Method 2
Access the “Keypad date/time" section by means of a valid PIN.
Follow the instructions described in Method 1 .
5-8
Keypad settings
This option allows you to program the display and buzzer settings.
•
Brightness - the level of brightness of the display backlight and LEDs when
you press any key (duration 20 seconds).
• Standby brightness - the level of brightness of the display backlight and
LEDs during standby status.
• Contrast - allows you to adjust the black/white contrast.
• Volume - allows you to adjust the buzzer volume (3 levels available).
•• Off
•• Low volume
•• High volume
• Keypad options :
•• Temperature off - if enabled, the temperature value (read by the built-in
temperature sensor) will not be shown (JOY/MAX keypads only).
•• NoExitTimeSignal - if enabled, the buzzer will not emit audible signals
during partition Exit time.
•• NOEntryTimeSignal - if enabled, the buzzer will not emit audible signals
during partition Entry time.
•• Beep on output - if enabled, the buzzer will emit audible signals during
partition Exit time.
These settings apply only to the keypad you are working on, and will be saved even in
the event of panel shutdown.
Via Keypad
Method 1
Activate the shortcut assigned to the "Keypad set.menu” (shortcut n.18: ),
and associated with one of the following keys , ..., (shown on the
display), with or without code entry, to access the “Keypad settings”section of the
User Menu.
1. Use keys and followed by to select the required parameters.
2. Use keys and to increase or decrease the value of the selected
parameter. To activate the selected option press , to deactivate it
press .
3. Press to save.
18:23 30/10/2011
DDDDDDD
User Code
View
Outputs ON/OFF
Set date/time
Type in code
******
Method 2
Method 2
Method 2
18:23 30/10/2011
dd/mm/yyyy
Method 1
Brightness
18:23 30/10/2011
DDDDDDD
User Code
Outputs ON/OFF
Set date/time
Set Keypad
Type in code
******
Method 2
Method 2
Method 2
Set Keypad
Brightness
BrightnessStdby
Contrast
Method 1