User’s Manual
Using the system
33
5-11
Teleservice request
This command sends a call to the installer company.
Your installer must enable control panel option “Num10ForTeleserv”, otherwise
this function will not be available.
Via Keypad
Method 1
Activate the shortcut assigned to the “Teleservice req.” (shortcut n.8:
).
Method 2
Access the "Teleservice" section of the User menu by means of a valid PIN.
Via Reader
Hold a valid digital key in the vicinity of the reader until the reader LEDs or
display indicates "Teleservice Request" (shortcut n.8).
5-12
Overtime request
This operation can be carried out under the following conditions only.
•
The partition concerned must be timer-controlled.
•
The auto-arm option must be enabled (refer paragraph
5-4 Activations
).
Each overtime request postpones the auto-arming operation by 30 minutes.
Via Keypad
Method 1
Activate the shortcut assigned to the “Overtime” (shortcut n.7:
).
Method 2
Access the "Overtime req." section of the User Menu by means of a valid PIN.
Via Reader
Hold a valid digital key in the vicinity of the reader until the reader LEDs or
display indicates "Overtime" (shortcut n.7).
Over-the-phone
Type-in the PIN of a user code followed by “
#
”, then press the key (from “
0
” to
“
9
”) which the installer has programmed to activate “Overtime” (shortcut n.7).
Via Wireless keyfob
Push the respective button on the keyfob and verify the outcome of the requested
operation, as described in paragraph
2-6-1 Air2-KF100 Wireless keyfobs
.
18:23 30/10/2011
DDDDDDD
User Code
Change PIN
TelephoneNumbers
Teleservice req.
Type in code
******
Method 2
Method 2
Service call
activated
Method 1
18:23 30/10/2011
DDDDDDD
User Code
TelephoneNumbers
Teleservice req.
Overtime
Type in code
******
Method 2
Method 2
Auto-arming
postponed
Method 1
Summary of Contents for SmartLiving 10100L
Page 45: ...User s Manual 45 Notes...
Page 46: ...46 User s Manual...
Page 47: ...User s Manual 47...
