36
Using the system
User’s Manual
5-16-2
User to panel calls
If the “Answerphone” function (refer to paragraph
5-4 Activations
) is enabled,
users can call the control panel from any remote telephone and send commands
to the system (refer to paragraph
3-2 Shortcut with code
) and/or activate Listen-
in sessions (refer to paragraph
5-14 Listen-in
) in the following way.
1. Dial the control panel telephone number.
2. Allow the phone to ring for the pre-established number of rings. The control
panel will answer and will play message n.216.
3. Type in your PIN followed by “
#
”.
4. The control panel will activate the voice function which will announce the
available shortcuts and the number keys to press.
5.
As soon as the selected number is pressed on the telephone keypad, the control
panel will activate the corresponding shortcut.
If the system is equipped with a Nexus dialer, the user can operate on the control
panel via voice call to the SIM card of the Nexus. If duly configured (by the
installer), the user will receive feedback (SMS text message or ring) from the
Nexus relating to successfully implemented commands.
5-16-3
SMS text message to the user
If the system is equipped with a duly programmed Nexus dialer, the user may
receive SMS text messages signaling that events have occurred.
If an event (which has been duly configured by the installer) occurs or restores,
the control panel will send notification to the programmed users via SMS.
5-16-4
SMS text message to the
control panel
If the system is equipped with a duly programmed Nexus dialer, the user can
operate on the control panel by sending SMS text commands to SIM card of the
Nexus.
Users who wish to activate a command via SMS text must enter the command
details as follows:
<xxxxxx> <SMS Text>
where
•
<xxxxxx> stands for the user's PIN
•
a blank space must be keyed in after PIN entry
•
<SMS Text> which is the command identifier - this parameter must be
provided by your installer.
If duly configured (by the installer), the user will receive feedback (SMS text
message or ring) from the Nexus relating to successfully implemented
commands.
SMS TEXT AT DEFAULT
The SmartLiving control panel is programmed with five predefined default
commands:
•
Balance enquiry relating to the SIM card of the Nexus
If the following SMS text message is sent:
<xxxxxx> CREDIT BALANCE
where <xxxxxx> stands for the user's PIN - the user will receive an SMS text
message indicating the remaining credit (balance).
•
Status enquiry relating to the Nexus
If the following SMS text message is sent:
<xxxxxx> STATUS
where <xxxxxx> stands for the user-access PIN - the user will receive an SMS
text message indicating the:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• device tamper status
•• BUS status
•• Balance (remaining credit)
•
Inhibition (using the “EXC” or “ESC” command) or activation (using the “INC”
command) of the control panel zones
If the following SMS text message is sent:
Summary of Contents for SmartLiving 10100L
Page 45: ...User s Manual 45 Notes...
Page 46: ...46 User s Manual...
Page 47: ...User s Manual 47...
