IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 80 / 212

EN
6 - USE AND OPERATION SIR 52 MS52 P/F
6 - Pag. 8 / 30
CONTROLS FOR MANUAL OPERATION OF DRILLING MACHINE.
F21 Button STEP BY STEP OPERATION
Press F21 to activate Step by Step operation.
After pressing the button, the button led will light up. Press F21 many times to restore
drilling machine working cycle. In case F22 Led lights up because of signal failure of
microswitch sensors, press both F21 and F22 at the same time to restore drilling machine
working cycle.
F22 SENSOR DISABLING BUTTON
When the button led lights up, the drilling machine sensors can be deactivated by pressing
this button. (For example, if no bar is present, it is possible to press this button for step-
by-step operation).
F23 SPINDLE RETURN BUTTON
By clicking this button when the spindle has not completely left the bar being machined,
the spindle returns to the rest position. To carry out the above mentioned operation, the
drilling machine working cycle must be over and the machine must be in wait position.
F24 NOT ENABLED BUTTON
F25 RESET 5" Button
To enable the reset button, manual operation mode must be selected.
Press this button during the Step-by-Step operation to stop the process.
Press this button to release buttons F26-F29, in case the corresponding LEDs are on.
F26 LEVER UP/DOWN BUTTON
Press this button to start movement, press again for lever return.