IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 162 / 212

EN
10 - DRILLING MACHINE SIR 52 MS52 P/F
10 - Pag. 14 / 20
10.3.2 USE AND ADJUSTMENT
The automatic operation mode of the drilling machine is activated when parameter 16 is set to
1 from the operator's panel.
If parameter 16 is set to 0, no bar facing cycle will be performed on the bar feeder.
INFORMATION
Before starting the bar facing cycle on
the bar feeder, the following adjustment
should be carried out when bar feeder
and lathe are not working and the
drilling unit is in retracted position
("home position" or zero point).
1) By means of a hand-puller or a pneumatic
puller, ass a Hainbuch gripper (bar clamping
system) to the drilling unit; the size of the
gripper should be 65 and should fit the bar
diameter (gripper code is Hainbuch SK65BZ##,
where ## indicate the bar diameter in mm).