IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 136 / 212

EN
9 - PART REPLACEMENT SIR 52 MS52 P/F
9 - Pag. 4 / 16
Belt stop signal check
Once one or more belts have been replaced, check
and if necessary adjust the position of the cams
controlling the belts lowering and lifting.
- Lower belts completely.
- Cam (B)shall be at the low limit switch.
- Bring belts in the upper position.
- The cam (C) must be up in its end of stroke
position.
- The cam (B) must cover sensor (E).
CAUTION:
Should upper belts be too tight, the
relevant supports may bend.
Otherwise, a loosening of upper belts
prevents some bars from reaching the
selection device.
Legend
A Belt locking plate (see figure in previous page).
B Cam
C Cam
D Lower end-of-travel transducer
E Upper end-of-travel transducer
F Upper end-of-travel transducer