IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 56 / 212

EN
5 - ADJUSTMENTS AND SETTING-UP SIR 52 MS52 P/F
5 - Pag. 6 / 22
5.3 GUIDE CHANNELS - ADJUSTMENT
DANGER - WARNING:
the following procedures must be carried out or authorized by a responsible and
expert operator, who owns the selector key to carry out this procedure.
5.3.1 Standard Working Mode
- Turn selector switch to position
and open the guard.
- Open the sprockets by pressing the key .
- Adjust the diameter of the guide channel
selecting one of the four settings as follows
(fig. 10):
• loosen pin (B);
• screw pin (B)down into one of the
positioning holes, 1,2,3 or 4;
• make sure the pin secured correctly.
- Close sprockets by pressing key.
INFORMATION
Diameters not included in the table
"RECOMMENDED ROUND BAR Ø" may cause vibrations and failures to the bar
feeder.
It may therefore be necessary to reduce bar rotation speed.
For further information regarding work diameter, contact IEMCA Customer Service.