IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 52 / 212

EN
5 - ADJUSTMENTS AND SETTING-UP SIR 52 MS52 P/F
5 - Pag. 2 / 22
5.1 SIR 52-MS 52 P RACK MAGAZINE - ADJUSTMENT
5.1.1 Bar selection - Adjustment
Turn the adjustment screw (B)to adjust the position
of the limit stop (A) according to the bar diameter.
The adjustment value (C) should be about 1 mm less
than the diameter of the bar.
For bar diameters 15 to 25 mm, install guide
channel(D) and fix it with the screws (E); value (F)
corresponds to the bar diameter plus 1 mm.
For bar diameters 11 to 15 mm, it is recommended
to install guide channel (D) though not strictly
necessary.
For bar diameters over 15 mm, loosen screw (G) and
remove guide channel (D).
Both guide channel (D) and support (H) are supplied
with the bar feeder.