IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 161 / 212

10 - DRILLING MACHINE SIR 52 MS52 P/F
EN
10 - Pag. 13 / 20
Reset the drilling machine following these instructions:
1) The drilling unit must be in wait position, otherwise press the RESET button to move it to
wait position.
2)
Keep pressing button F25 for 5 seconds: all the devices on the drilling machine will be
released.
3)
If a bar is closed in the clamp, the levers will not come down.
4)
The motors of the drilling unit will stop.
5)
Press button F27 and then F30 to move the bar backward, after the motor has been driven
backward and the bar detecting photocell has been released.
6)
Press button F25 again to open the chucks of the feeding unit and to move down the
loading levers to the rest position.
S38 Button Drilling machine stop/Spindle return
- Press this button to restore the drilling machine to normal operation (alarm nr. 60 " Drilling
machine cover" will be displayed). Keep pressing the button to let the spindle return to the
rest position "0 position". Pressing button F23 it is possible to reach the retracted position.
- This position allows spindle or tool maintenance. After maintenance has been completed,
press button S32 to reset alarm nr. 60 and restore drilling machine to normal operation.
- If button S32 is pressed as soon as alarm nr. 60 " Drilling machine cover" is displayed the
drilling machine is restored immediately to normal operation.
Press this button to stop drilling machine operation without stopping either bar feeder or
lathe working cycles.
Press button S38 and then button F30 to restore the position of the devices of the drilling
machine and restore operation.