IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 166 / 212

EN
10 - DRILLING MACHINE SIR 52 MS52 P/F
10 - Pag. 18 / 20
11) Install the screw (A) in the hole
corresponding to the diameter of the point used
to bore (Ø-20mm; Ø-15mm;Ø-10mm).
INFORMATION:
Manufacturing calibration of the
pressure switch referred to the barstop:
- Empty Air pressure from 1,8 to 2,2 bar;
- Change over Pressure 3 bar.
For possible pressure switch control or
calibration
To control the pressure switch, please
contact Iemca Service.
12) Bar pushers should be provided with pipe grippers suitable for the holes to be drilled.
13) On the operator's panel, set correct cutting speed and feeding parameters according to
the diameter of the hole and to the type of material or choose one of the parameter lists
that are available on the system, only in case the required conditions (i.e. Spindle tip
diameter, bar material) correspond to the conditions on one of the available parameter lists.
For any further information concerning how to enter an available parameter list or how to
set new operation parameters, please see chapter ... or the keyboard instruction manual...
ATTENTION!
Any work must be carried out by qualified technicians and/or persons who will
follow all safety guidelines in respect of the existing norms.