IEMCA SIR52 MS52 P, Manual For Use And Maintenance

Page: 164 / 212

EN
10 - DRILLING MACHINE SIR 52 MS52 P/F
10 - Pag. 16 / 20
5) Remove the screw (A) referred to the barstop
block.
6) Turn the barstop (B).
7) Use the special puller to remove or replace the
Hainbuch gripper.
8) Add a spindle tip on the spindle, making sure it
is suitable to the material to be drilled. The
diameter of the spindle tip should be at least
5mm smaller than the bar diameter.
Install the spindle tip on one ABS 50 KOMET
holder.
The spindle tip on the holder should be
protruding 115mm from the spindle shaft end
(see picture).
Please use the following sequence to drill:
a)Hole D=20 mm: insert drill Komet Trigon V30-
92000 ABS50
For difficult drilling works we recommend: Extension KOMET ABS 50-V50 A20 00550 + insert
drill KOMET KUB TRIGON V30-31500 or KOMET KUB QUATTRON U10-71501.