IBM Multiprise 3000 S/390, Installation Manual

Page: 119 / 175

Running the Input/Output Configuration Program (IOCP)
1 Before you start
The Input/Output Configuration Program (IOCP)
can run in either ESA/390*, or LPAR mode. The
customer must provide you with an input file for
this program. The input file is in 80 column card
image format and can be provided on a channel
attached tape or on a Hardware Management
Console or a I/O and Support Processor diskette.
The system tape must be in Extended Binary
Coded Decimal Interchange Code (EBCDIC)
format. The diskette must be in American National
Standard Code for Information Interchange (ASCII)
format. The input file contains all the I/O
information necessary for the program to define the
channel paths, control units, and devices.
For additional information about the IOCP program,
refer to
Input/Output Configuration Program Users
Guide, GC38-0401 and the Stand-alone IOCP
Users Guide GC38-0458
Note: Before continuing with this procedure you
will need to LOG ON the Hardware
Management Console as the
SYSPROG
the password is PASSWORD .
Go to “Establishing a CPC Console Connection” on
page 6-42 to work from the Hardware
Management Console
Chapter 6. Completing the Installation
6-41