IBM Eserver xSeries 360 Type 8686, User Reference Manual

Page: 118 / 184

104
IBM® xSeries 360: User’s Reference
289 An error occurred during POST memory tests and a failing DIMM was
disabled.
Note: You can use the server with decreased memory.
Action: 1. If you just installed memory, verify that the new memory is
correct for the server. Also verify that the memory is installed
and seated correctly. Start the Configuration/Setup Utility
program and select
Memory Settings from the Advanced
Setup menu to enable the DIMM.
2. If the problem remains, replace the failing DIMM.
If the problem remains, call for service.
301
303 An error occurred during the keyboard and keyboard controller test. These
error messages also might be accompanied by continuous beeping.
Action: Ensure that:
• Nothing is resting on the keyboard and pressing a key.
• No key is stuck.
• The keyboard cable is connected correctly to the keyboard
and to the correct connector on the server.
Running the diagnostic tests can isolate the server component that failed,
but you must have the system serviced. If the error message remains, call
for service.
Note: If you just connected a new mouse or other pointing device, turn
off the server and disconnect that device. Wait at least 5 seconds;
then, turn on the server. If the error message goes away, replace
the device.
602 Invalid diskette boot record
Action: 1. Replace the diskette.
2. If the problem remains, make sure that the diskette drive
cables are correctly and securely connected.
3. If the problem remains, replace the diskette drive.
If the problem remains, call for service.
604 An error occurred during a diskette drive test.
Action: 1. Verify that the Configuration/Setup Utility program correctly
reflects the type of diskette drive that you have installed.
2. Run the diagnostic tests. If the diagnostic tests fail, call for
service.
662 A diskette drive configuration error occurred.
Action: If you removed a diskette drive, make sure that the diskette drive
setting is correct in the Configuration/Setup Utility program. If the
setting is not correct, change it.
If the problem remains, call for service.
Table 12. POST error messages.
POST message Description