IBM Eserver xSeries 360 Type 8686, User Reference Manual

Page: 152 / 184

138
IBM® xSeries 360: User’s Reference
NDIS (Windows 2000 or Windows NT) driver messages
This section contains the error messages for the network driver interface specification
(NDIS) drivers. The explanation and recommended action are included with each
message.
Please unload all LAN drivers before
unloading AFT.NLM. Explanation: An attempt was made to unload the AFT.NLM module before
unloading the adapter driver.
Action: Unload the adapter driver before unloading the AFT module.
Table 18. NetWare or IntraNetWare system ODI driver teaming messages for the Ethernet controller.
Message Description
Table 19. NDIS (Windows 2000 or Windows NT) driver messages for the Ethernet controller.
Error code (hex) Description
0x00 Explanation: The driver could not register the specified interrupt.
Action: Using the Configuration/Setup Utility program, make sure that a PCI interrupt is assigned to
the Ethernet card, and that Ethernet is enabled.
0x01 Explanation: One of the PCI/PCI-X cards did not get the required resources.
Action: Using the Configuration/Setup Utility program, make sure that a PCI interrupt is assigned to
the Ethernet card, and that Ethernet is enabled.
0x02 Explanation: Bad node address (multicast address).
Action: Make sure the locally administered address is valid, if one is specified. The address cannot
be a multicast address.
0x03 Explanation: Failed self-test.
Action: Make sure a cable is attached to the Ethernet connector. If the problem remains, call for
service.
0x0D Explanation: Could not allocate enough memory for transmit queues.
For Windows NT:
Action:
1. From the Windows NT desktop, click Start
→
Control Panel
→
Networks
→
Adapters .
2. Select an IBM Ethernet adapter from the list.
3. Click Properties
→
Advanced .
4. Lower the resource values that apply to the transmit queue.
For Windows 2000:
Action:
1. From the Windows 2000 desktop, click Start
→
Settings
→
Control Panel
→
Network and
Dial-up Connections .
2. Right-click an IBM Ethernet adapter in the list and click Properties .
3. Select a component and click Configure .
4. Click the Advanced tab and lower the resource values that apply to the transmit queue.